Oper Way To Put Hinge On Door And Jamb

Door hinges which way is up.

Oper way to put hinge on door and jamb.

Once the door is shimmed all the way up tight to the quarter check the reveal along the top and the sides. Lay the old door back on top of the new one and then transfer your hinge mortise lock set mortises and door hole outlines. Begin with the mortises on the door then the mortises on the jamb. Attach the hinges to the jamb and the door.

Double check to make sure that your outlines match the same location on the door and jamb before moving to the next step. However when hanging my own doors i like to put the three knuckle leaf on the door for the simple reason that it s easier to re hang the door. Attach hinges cut the head jamb to a length equal to the door width plus the combined rabbet or dado depth plus slightly more than 1 8 inch. If the existing jamb is out of square it will show up along the top.

Step 2 insert a shim into the cutout. Trace around the hinge. I took all the doors off the hinges and the hinges off the jambs and doors in order to paint all the woodwork trim and doors in my house. Because we haven t routed for the hinges yet and they are still attached to the jamb it should be a snug fit for the width.

Notes on door hinge placement hinge placement varies depending on whether your door is left swing or right swing in swing or out swing. The depth of the hinge on the jam should always be as thick as the hinge is. Use a combination square to lay out the mortises making sure that you re transferring the proper width and height of the outlines. Using a mortising template route matching mortises for the hinges on the door and jamb.

When you install a door hinge you need to make notches for it on the edge of the door and on the jamb or the door won t close properly. Cut shims to match the dimensions of the hinge cutouts. Hinges have two parts one with 2 rings and another with 3 rings that the pin passes through. Attach it using your hammer and a nail or two.

These notches or mortises should be just deep enough to. I wasn t paying attention and forgot to note which part of the hinge goes back on the door and jamb. Put your hinge in place on the door and the jamb and use a carpenters pencil to carefully trace around the hinge.